Optoma OWM1000 Specifications download pdf (Page 3)

Cable Routing

Fine Adjustment

i. Remove knock-out to reveal access hole i. Insert Cable Protection Grommet and feed

Cables in to support.

Remove knock-out nearest to desired exit point

depending on position of projector. To remove

knock-out follow Stage '6b'. Route cable out of

support and through cable protection grommet.

Secure cable protection grommet into knock-out

hole before adjusting cables.

Tilt - Loosen bolt 'a' (x2). Adjust projector to required angle. Re-tighten bolt 'a' (x2).

Fine level - Adjust thumbwheels 'b' independently to achieve desired level.

Lateral Positioning - Loosen Projector fixing screws slightly and slide the projector until image is

centralised to screen.

NOTE: Do not fully remove any of the adjustment wheels or fixings described above

a b

Entry option through wall plate or through wall trim Entry option bypassing wall plate and in to support

Cable exit from mount to projector

Projector removed in this view for clarity

1 2 3 4

No comments

Optoma OWM1000 Specifications Page 3