Optoma W307USTI User's Guide download pdf (Page 49)

English

Appendices

Replacing the lamp

The projector automatically detects the lamp life. When the

lamp life is nearing the end of use, you will receive a warning

message.

Lamp is approaching the end of its useful life

Replacement suggested!

Warning! Lamp

When you see this message, please contact your local reseller

or service center to change the lamp as soon as possible.

Make sure the projector has been cooled down for at least 60

minutes before changing the lamp.

Lamp Replacement Procedure:

1. Switch off the projector power by pressing the “ ” button.

2. Allow the projector to cool down for at least 60 minutes.

3. Disconnect the power cord.

4. Unscrew the two screws on the cover. 1

5. Lift up and remove the cover. 2

6. Unscrew the two screws on the lamp module. 3

7. Pull up the lamp handle and remove the lamp module slowly and carefully. 4

To replace the lamp module, reverse the previous steps.

8. Turn on the projector and use “Lamp Reset” after the lamp module is re-

placed.

The screws on the 

lamp cover and the

lamp cannot be

removed.

The projector can-

not be turned on if

the lamp cover has

not been placed

back on the projec-

tor.

Do not touch the 

glass area of the

lamp. Hand oil can

cause the lamp to

shatter. Use a dry

cloth to clean the

lamp module if it

was accidentally

touched.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 60 61

Comments to this Manuals

No comments

Optoma W307USTI User's Guide Page 49

Comments to this Manuals

Related products and manuals for Data projectors Optoma W307USTI