Optoma HD20 User Manual download pdf (Page 43)

English

Appendices

Lamp Replacement Procedure:

1. Switch off the power to the projector by pressing the “ ” button.

2. Allow the projector to cool down for at least 30 minutes.

3. Disconnect the power cord.

4. Unscrew the two screws on the cover. 1

5. Lift up and remove the cover. 2

6. Unscrew the two screws on the lamp module. 3

7. Lift up the lamp handle and remove the lamp module slowly and carefully. 4

To replace the lamp module, reverse the previous steps.

8. Turn on the projector and use “Lamp Reset” after the lamp module is

replaced.

Lamp Reset: (i) Press “Menu”  (ii) Select “SYSTEM”  (iii) Select

“Lamp Settings”



(iv) Select “Lamp Reset”



(v) Select “Yes”.

 The screws on the

lamp cover and the

lamp cannot be

removed.

 The projector

cannot be turned

on if the lamp

cover has not been

placed back on the

projector.

 Do not touch the

glass area of the

lamp. Hand oil can

cause the lamp to

shatter. Use a dry

cloth to clean the

lamp module if it

was accidentally

touched.

Note

1 ... 42 43 44 45 46 47 48 49 50

No comments

Optoma HD20 User Manual Page 43