Optoma Optoma EP550 User Manual download pdf (Page 18)

English

Maintenance

w Changing the lamp

Make sure the projection display has cooled for at least 30 minutes before changing

the lamp. After you slide the lamp latch and open the lamp door, you will see two lamps

inside; one is in “usage” position, the other is in “spare” position. Refer to the lamp

changing directions below.

Lamp Changing Directions:

Warning: Lamp compartment is hot! Allow it to cool before changing lamps!

Notice: Use only USHIO or OSRAM HLX 64663T EVD 36V 400W lamp. Please

contact your local supplier or service center.

Slide the lamp latch; open the lamp compartment.

Move the lamp assembly by the long pin.

Slide the lamp assembly sideways to place the

spare lamp into the “usage” position. Remove the

used lamp.

Hold the new lamp with a plastic bag or clean cloth

and then push it firmly into the socket. (Finger oil,

dust or water will damage the lamp.)

Be sure the lamp assembly is set firmly back in

position. Then close the lamp door.

Lamp Assembly

Lamp Latch

Long Pin

Lamp Door

“Usage” Position

1 2 ... 13 14 15 16 17 18 19 20 21

No comments

Optoma Optoma EP550 User Manual Page 18