Optoma S313 User Manual download pdf (Page 21)

EN-21

Connecting an HDMI source device

Examine your Video source device to determine if it has a set of unused

HDMI output jacks available:

 If so, you can continue with this procedure.

 If not, you will need to reassess which method you can use to connect to

the device.

To connect the projector to an HDMI source device:

1. Take an HDMI cable and connect one end to the HDMI output jack of the

HDMI source device.

2. Connect the other end of the HDMI cable to the

HDMI

jack on the

projector.

Connecting a Component Video source device

Examine your Video source device to determine if it has a set of unused

Component Video output sockets available:

 If so, you can continue with this procedure.

 If not, you will need to reassess which method you can use to connect to

the device.

To connect the projector to a Component Video source device:

1. Take a VGA (D-Sub) to HDTV (RCA) cable and connect the end with 3

RCA type connectors to the Component Video output sockets of the

Video source device. Match the color of the plugs to the color of the

sockets; green to green, blue to blue, and red to red.

2. Connect the other end of the cable (with a D-Sub type connector) to the

VGA1/YPbPr

VGA2/YPbPr

socket on the projector.

Important



If the selected video image is not displayed after the projector is turned on and

the correct video source has been selected, check that the Video source

device is turned on and operating correctly. Also check that the signal cables

have been connected correctly.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 66 67

No comments

Optoma S313 User Manual Page 21